Eastwood DTM (Direct to Metal) Epoxy Primer 1:1 primes and seals with excellent adhesion and corrosion resistance.
Eastwood's Epoxy Primers are user friendly, 2 component primer/sealer that dries fast and maintains good color hold out on steel, aluminum, fiberglass, body fillers and existing finishes. Easy 1:1 mixing with catalyst. Sands easily 2 to 3 days after application. Contains no lead, chromate or isocyanates."p" MIXING RATIO "p" After shaking/stirring primer, thoroughly mix one part primer with one part catalyst. No induction time is required with this epoxy system. "p" SPRAY GUN SETUP "p" HVLP Gun: Fluid Tip 1.4-1.8 mm Inlet Spray Pressure 25-30 psi "p" Conventional Gravity: Fluid Tip 1.4-1.6 mm Inlet Spray Pressure 45-55 psi "p" Conventional Siphon: Fluid Tip: 1.6-1.8 mm Inlet Spray Pressure 45-55 psi "p" APPLICATION INSTRUCTIONS "p" Eastwood Epoxy Primer should be applied in medium wet coats, with a 30-minute flash period between each (at 70 Â°F). Typically, one to two coats is enough to achieve the desired 1 mil. dry film thickness, though more material may be applied as needed. Additional build requires longer flash periods between coats. Epoxy primer may be top coated after approximately 30 minutes (wait 45-60 minutes after applying more than two coats), or up to about five days. After five days, primer MUST be scuff sanded prior to topcoat application. May be sanded (wet) the day after application. Wait two to three days before sanding dry.
|"th" Epoxy Primer White Quart "th" Epoxy Primer Catalyst|